Answer / sohail malik sngpl pakistan

Antisurge control system is basically to protect the for
example boost compressor.
surge may occur in a gas compressor when the suction flow
may decreases and the isontropic head going to rise then
our surge margin reduces and condition goes to compressor
surge.
in anti surge control system an control valve works for
example if suction flow reduces this valve open to allow
discharge pressure into suction resultant the our condtion
goes to safe margin.
in antisurge control system if 25% reduces in suction flow
antisurge system generate 1 pulse and if 5 pulses generate
in 10 seconds the turbine engine or other facility should
be Shutdown.

Answer / ales jan

above ans is right

Answer / senthil.doosan@yahoo.com

it is not simple..
its complicated.
setpoints we have
-High surge flow
-low surge flow
-high surge pressure
-low surge pressure
-safety margin
for actual calculated flow we need
-molecular weight
-actual pressure
-actual temp
-flow coefficient
-internal pipe dia
-comressor flow
-density of gas
-dp
Controls:
we have
- surge flow control(Actual flow with calculated flow)
- discharge pressure control( Actual dicharge pressure with
setpoint pressure)
finaly,
the maximum of this control is given as deviation to the
master control which control the antisurge valve..

Can anybody tell me the exact explanation for Functional calibration?When it should be done on process or on lab? Advanced Thanks

2 Answers  

---

thru which signal does µP communicate with memory

3 Answers  

---

Linear amplifier.

0 Answers   CCIE,

---

when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??

0 Answers  

---

Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?

0 Answers  

---

What is close loop ?

1 Answers   College School Exams Tests, GMR,

---

Transducer Input 0 to 230 v ac Output-0 to 10vdc Receiver Input 0 to 10 vdc and Output 4 to 20 ma How?

1 Answers  

---

Explain signal isolator

0 Answers  

---

What is the difference between EPROM & EEPROM.

1 Answers   Sabic,

---

How to calibrate DP tramitter in flow measurement application? consider my range of flow is 0 to 2000 kg/hr ? please give calculation of , How much pressure applied on low pressure side and high pressure side please give detail of calculation .... It so important for me please reply as soon as possible

1 Answers  

---

there are two candidates p and q in an election.During the campaign,40% of the voters promised to vote for P ,and rest for Q.however, on the day of election 15% of the voter went back on their promise to vote for P and instead voted for Q. 25% of the voters went back on their promise to vote for Q and instead voted for P.suppose,P lost by two votes,then what was the total no. of voters.

1 Answers   GATE,

---

hi i'm an Instrumentation student,i have one doubt that we can call- > computer science as CS > Information science as IS > Electronics & communication as E & C In the same way what is short term for Instrumentation....?

11 Answers  

---