i/p sec of atransformer is 230V 5a o/p spc is 12v 1a so i/p power will be 1150

i/p sec of atransformer is 230V 5a o/p spc is 12v 1a so i/p
power will be 1150w o/p power will be 12w then how the
power transfer theorm matching with this??

Question Posted / mithun_018

2 Answers
4710 Views
Bosch, Surya Software, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

i/p sec of atransformer is 230V 5a o/p spc is 12v 1a so i/p power will be 1150w o/p power will be ..

Answer / sambi reddy

power transform theorems says ;i/p power = o/p power.
it dosent mean that power will be electrical .
there is power ; megnetic power & losses.
the ip power is 1150w at i/p side and linking flux is
depend on the number of o/p side turn and we get 12w as o/p.
just like
i/p power= total o/p power
i/p power= o/p electrical power+ o/p megnetic power+ losses
(copper & iron losses).

Is This Answer Correct ?

6 Yes

0 No

i/p sec of atransformer is 230V 5a o/p spc is 12v 1a so i/p power will be 1150w o/p power will be ..

Answer / shanmugam

The Maximum Power Transfer Theorem states that the maximum
amount of power will be dissipated by a load resistance if
it is equal to the Thevenin or Norton resistance of the
network supplying power.

The maximum Power is transfer to the load,Whenever the input
and output impedance is matched.

We have to consider the impedance of that pfimary and
secondary side.

Is This Answer Correct ?

1 Yes

0 No

Post New Answer

More Electronics Communications Interview Questions

HOW TO CHANGE SCHEDULING ALGORITHM OF A LINUX KERNEL THREAD DYNAMICALLY

1 Answers Anna University, Wipro,

how a log ratio amplifier works?

0 Answers

What is DTX? Why is it used?

2 Answers

You Are Fresher?Wana Start Your Carrer In Intelli Group Hyderabad Only possible via Niteo IT Consultant...

2 Answers

significance of transistor number

1 Answers

What is channel coding?

0 Answers

What is meant by step-down cyclo-converters?

0 Answers

1.Why we have to use inductor in circuits, what is their behavior? 2. Why we have to use capacitor in circuits, what is their behavior?

1 Answers Instronix,

I am completed B.E(ece) and i have 3 years of experience in HT line , is there any chance to ger c license please guide me Thanks & regards 965550212U

0 Answers Honeycomb Technologies,

how to interface hall effect sensor with 8051 microcontroller?

0 Answers

4. How are the wattmeter readings equal in 2 Wattmeter method at UPF? Establish the condition mathematically?

0 Answers

Define digital system?

0 Answers

For more Electronics Communications Interview Questions Click Here