Answer / Sandip Kumar

The percentage increase in length of the dead-end clamp for a Hawthorn bus bar conductor depends on the type of metal used, its temperature, and other factors. The exact value can usually be found in the manufacturer's specifications or guidelines. The applied pressure during hydraulic pressing is also specified by the manufacturer and depends on factors such as the material properties, the diameter of the bus bar, and the desired clamping force.

What are the three constants associated with a steady state error?

1 Answers  

---

can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.

1 Answers  

---

Any one can explaination about calibration with rotating sub standards?

1 Answers  

---

HOW TO WORK A VFD?SAY SIMPLE METHOD

2 Answers   GE,

---

is it possible to say motor horsepower number without seeing name plate(when name plate damaged)

4 Answers  

---

Can I use star delta connected induction motor for dual supply voltage?

1 Answers  

---

Why we use mho Relay in long transmission line?

1 Answers  

---

how will reduce the voltage. if 12volt/250ma transformer toreduce 6 volt

1 Answers  

---

im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar

1 Answers  

---

PLC Training in chennai | PLC Training institute in chennai, PLC Training center in chennai | Best PLC Training in chennai | PLC Training course in chennai | SCADA Training in chennai | PLC Training in india

1 Answers   Exide,

---

Why is the earth fault relay connected to the Yellow Phase?

4 Answers  

---

Can we step up a 230V supply to 400V using a single phase transformer??

2 Answers  

---