Answer / balaji

it decreases the efficiency of the turbine
basically, staeam extractions is done in the steam turbine
to recover the part of the heat loss in the condenser.
at the same time we are loosing work done also.
if we extract more steam from turbine, work done by the
steam turbine will reduce.

why the people sitting in the train doesn't get shock whilethat man getting shock from top of the train?

0 Answers   RRB,

---

How curvature effect is consideed in spring design?

1 Answers  

---

types of law of evoporation

1 Answers   ACB Group, Tata Motors,

---

how can I calculate daya of pump

0 Answers  

---

What are the performance expectations of this position over the first 12 months?

1 Answers  

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

Plese give us information Service Special Tools for Hydraulic,Trasmission,Main clucth,Rear axle etc for Mahindra Tractor 6030-4WD,Like SST Number,Discription,Price and Dimension or Photograph if u have.Thanks

0 Answers   MAHINDRA,

---

What is mechanism?

0 Answers  

---

What does angular momentum mean?

0 Answers  

---

how could you diffrentiate between mild steel and stainless steel by using single object. both appears same.

4 Answers   L&T,

---

What are the causes of main engine black smoke?

1 Answers  

---

What are the methods of heat transfer?

2 Answers   ABC Inc, RRB, Siemens,

---