we often use the word HT (high tension) line.or we say HT switch gear, whats do

we often use the word HT (high tension) line.or we say HT
switch gear, whats does HT basically mean. is it different
from high voltage.

Question Posted / sayan

1 Answers
3829 Views
I also Faced
E-Mail Answers

we often use the word HT (high tension) line.or we say HT switch gear, whats does HT basically mean..

Answer / k.prakashchandra

Both are the same as both mean 'pressure'

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

what is meant by cbct elr?

3 Answers

need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.

1 Answers

Why Power generation in India is at 50Hz while in America its 60Hz so is there any advantage/Disadvantage of this ??

38 Answers Australia Visa, College School Exams Tests, Fiat, InfoPlus, L&T, NTPC, TCS,

what is meant by VDC ?where its applicable ?

2 Answers

what is the basis for selection of Protection CT class ? How anyone can decide whether to go for 5P10 or 5P20 ?

3 Answers

the rating of fuse wire i always expressed in what?

3 Answers

how to select earthing wire? procedures and parameters?

2 Answers

how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.

1 Answers

how generater works

4 Answers

how work the lighting arrestor?

2 Answers

I have a question, I visit 01 site and face a problem, there is 2.5 ton Air Con working, when air con compressor is running at that time rectifier voltages are increasing upto 290-295 v and rectifier is giving main high alarm (rectifier is APC single phase), before starting compressor rectifier voltages was 230v. when air con is going off rectifier voltages are decreasing smoothly at its actual voltages 230v. Load on Genset phases is this: Red-13.5 amp AC (Air Con load), Yellow-1.7 amp AC (BTS lights etc.) and Blew-4 amp AC (telecom system load), Genset phase to phase and neutral to phase voltages are also ok. These are 10 sites having same system and same rectifier APC brand at every site 02 genset are working but the problem is same at all these 10 sites. What will be the reason behind???

1 Answers

what are the difference between AC lamp and DC lamp

1 Answers Apollo,

For more Electrical Engineering Interview Questions Click Here