Answer / aravind

the reason for using carbon brushes is it has resistance which is good enough for avoiding sparking during commutaion.This feature is also present in copper but frequently carbon is used

Answer / niranjan reddy

because the carbon is of less cost. and as frequent wear and
tear will occur to the brush due to rotation of the
motor...carbon is most economical.
and frm conduction point of view also it is good..so carbon
is used

hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)

0 Answers  

---

why frequency meter is connected in parallel in a circuit?

1 Answers   University of Engineering and Technology,

---

What is the feedback in the control system?

0 Answers  

---

what is load shedding

4 Answers   KSEB,

---

How out of step protection relay works?

0 Answers   APL,

---

While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?

0 Answers  

---

Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???

0 Answers  

---

What is meant by system?

0 Answers  

---

For a 500 MVA 400/220/33KV transformer following data given HV power = 500 MVA IV power = 500 MVA LV power = 5 MVA If input power is 500 MVA then how output power is (500+5)MVA. Can anyone help

1 Answers   MEIL,

---

what do u mean by bus bar?

6 Answers  

---

how many number of terminals are available in CURRENT TRANSFORMER

6 Answers   MSETCL Maharashtra State Electricity Transmission Co Ltd,

---

what is 33 /11kv transformer bdv

8 Answers   NMDC, TPPL,

---