How to reduce current flowing in neutral due to unbalanced load conditions in a three phase system.
1 4295why when i start my diesel generator it takes 1 minute or less then stop, and i checked the oil sensor is ok and when the generator start i can get 220 voltage but it it is stop after 1 minute or less, how can i solve this problem?
1 2731(1) From the following option, which option is correct for largest size transformer.? a)1KVA,25Hz , b)1KVA,50HZ , c)1KVA,60Hz , d)1KVA,100Hz
5 8959suppose i have two single and three phase induction motor,thier have not any rating on its panel,anybody can tell me which motor is single or three phase?
Doon,
1 3367Post New Electrical Engineering Questions
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
How to calculate VCB rating for 33KV ,25 MW Power line?
can i able to get bhel previous exam question paper?
i've iocl interview.. if you know the interview process please give me information..
where are the circulat the diesel in DG parts name with pictue
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
please give some hindalco placement papers for written exam
why lightning arrestor are made in two stack of insulator but why not cvt
How much minimum insulation required between 11kv/3.3kv transformer windings?
How to calculate the sag on transmission Lines.
XYZ
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
What the main causes of transient interruptions on Over-Head Distribution Lines?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
Electrical Engineering