DG use Rating KVA why1 2407
Dear sir my name Ankit i m Diploma holder present working in Welspun Corp ltd Anjar as Asst.engg (salary 14400/month ctc) i Would like to change my company also i have selected in ford India pvt ltd Sanand as trainee Tech with salary 12000/month so please suggest me for changing my job hope for *ve response1954
why an ideal voltage source has low internal resistance????1 2277
what is static frequency converter?what is the function...of sfc...?
what is difference between 5A and 100A CT constructional wise and operation?1 2183
what is the advantages og idmt relay over magnetic relay??
what is the working principle/operation/theory of 3-phase rectifier power transformer used in cold rolling mills.
Why in Hv transmission line as we see there are generally 6 or more than 4 conductor wires are used instead of 4 i.e. 3 for phase and 1 for neutral wire?????2 3169
How can we increase fuel-power ratio of any DG set?
Why use in ht motore
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
what is LSR?
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. 
Benifits of 3ph 4 wire metering over 3ph 3 wire
how make megger test for control cable like 12c x 1.5mm and what it apply voltage and test timing details.
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
what is meant by directional earth fault and non directional earth fault? describe both.
Iwould like to know barc interview questions
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
I am going to appear RRB Sr. Section Engineer Exam, Electrical. Can you send me previous year questions of RRB Electrical engineer. specially Section Engineer questions. my email id is email@example.com
How to calculate the heat load for a electrical room