I do wonder why current is present in neutral wire?i check single phase lead current feeding air conditioner...on its phase its current was 10A while same was 10A in neutral...as we know in neutral voltage is zero so if voltage is zero then how current appears on amp meter? my second observation is (just imagination)when I touch phase wire it give me shock but when i touch neutral nothing happens although as above its carrying current(amps) third but with same logic...as in simple Alternate current sine curve there is + and there is negative peak.means every time phase changing so how come every time same phase and same neutral stand (pardon for english mistakes)
1 2659What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
1178Post New Electrical Engineering Questions
1. A bomber drops a bomb from an aircraft flying at 2000 km/hr. at an altitude of 7km. The speed at which the bomb will strike the earth would be
what is earth-fault?when it occurs? to check where it occurs what type of test should we do?
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
What is the role of power pack in substation protection system?
Which Class insulation is prefered for the sandwich Busducts ? Why?
What is the difference IN MCCB's between thermal magnetic and electronic tripping system ?
What are the material used for inductance coil?
What do you mean by phasors?
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
What are the types of control system?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
if we give 60 hz single phase supply to the transformer used in europe , than what will happen
if the motor rated speed is 950rpm. how to change the above rated speed? is it possible?
