What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
1 7487If the maximum demand is 120 KVA in a building, then what is the Current taken according to load given ? Formula for it ?
3 5511Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
1607Radio Carbon dating is used in a) find diseases b) find the age of relics c) find the carbon content in the atmosphere d) none of these
2 3428why a single phase motor of same rating takes more amps than the three phase motor? as single phase motor at 230v takes 5amp per HP while 3 p motor takes 2.5amp per hp at 230v.
1 3986Post New Electrical Engineering Questions
Hi My dear all Friends, There is a question regarding HVAC Engineering and widely used in Power Projects. Question- What is the diffrence Between REF, SEF and Differential Protection....???? Where REF - Restricted Earth Fault SEF - Senstive Earth Fault.
which network topology offers the greatest level of tolerance?
how to do the ductor test?
How to Prepare preventive maintenance shedule of machine tool.
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
why impedance relay is used for medium transmission line protection
What is the difference between a Root Locus plot and a Bode plot?
What happens to voltage when current through the inductor is constant?
What is sink and source?
how to select electronic timer(Star-Delta) setting for diff. rating motors
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
Explain Circuit Breaker Trip Characteristics in detail.
explain single phase series motor
why we not used 11kva as a direct our electrnics component.
HOW TO CALCULATE THE VT SIZING?