IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
1899what are the functions & ratings of panels mentioned below: 1. Main LT Panel(MLTP) 2. Motor Control Centre(MCC) 3.Feeder pillars 4.Busducts
1 4816what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
2099Post New Electrical Engineering Questions
when elecromagnatic waves are propogated in a wave guide?
What is Surge Capacitor? Why it is require in Generator Circuit Breaker,inspite of surge arrester?
what is allowed value of zero sequence impedancce of 6.6 kv nuetral earthing transformer ?what is the actual value
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
what is vA rating and class of a ct.
ROC converges if poles and zeros lie inside a. Origion b. Z=1
i need mat lab program to find out the transmission line losses,regulation and losses
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
What is vacuum circuit breaker.define with cause and where be use it device?
what is Fault level? why it is calculated? how will u decide same for our plant?
How the PF control while running DG set with load
i need the curve duty cycle and amper for (150 kva @50% dyty cycle) transformer turn ratio :19 and vin 400
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
which is better to use svc or synchronous condenser why ?