In underground cables,we have a grading method called 'capacitance grading'.Why is it called 'capacitance grading' although we do not use any capacitor in it?
1 7802Post New Electrical Engineering Questions
what happen when power factor of 2 parallely operated transformer become equle?
The loads are connected with phase and ground then why current flow as the loads ?
why r we using shell transformer for low voltage
ANY ONE TELL ME ABOUT generator synchronization panel panel to synchronise 3 gen of 250kva both automatic and manual. 2 gen output vol 415 3ph, 1 gen output vol 400 3ph SEND THE DETAILS DIAGRAM ON THIS EMAIL ADDRESS ayazleo@hotmail.com as soon as possilble best ragrds electrical engineer ayaz mahmood SAUDI TECH
What is a dc motor?
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
what is a vector protection in transformer
Why synchronous motor is used in power factor improvement,dc series in lift
What is proportional controller?
What is meant by rotor?
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
What are the application of filter?
What will happen if the voltage in my house drops from 220V to any lower voltage?
What are the section criteria for cables. Now everywhere XLPE power cable is used or PVC is also used?.
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not