Interested to Buy Any Domain ? << Click Here >> for more details...
What happens to the terminal voltage of an alternator connected to a bus bar when it is suddenly disconnected from the bus bar??
2 5061When induction motor is started,we see all other electrial appliances connected on the same supply are dimmed out for some moment why?
4 6832Post New Electrical Engineering Questions
Why does the adjacent zone of protection overlap?
Yazaki india pvt ltd interview questions qurey related
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
Why air circuit breaker off due to power failure?
How to calculate the sag on transmission Lines.
What is the formula to find out two phase active & reactive power
How to calculate VA rating for CT or PT or Control Transformer?
Why should we hire you over the others waiting to be interview?
Draw the DOL starter and star delta starter drawing?
how many joint can done in HT line and what is life of the joint
what is ic 01,ic 06 ?is it types of cooling?
if we have 320KVA Genset kindly advice how much load we can put it.
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
What is line resistance of cable & how it can be measured ?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
