plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
Bhel,
1734In Transmission System if the potential difference at the two end of line are same then is the transmission of power will continue ? if yes then how.
IOCL,
1 1356WHAT WILL HAPPEN IF WE START A MOTOR WITH STAR & IT IS RUNNING WITH STAR CONNECTION INSTEAD OF DELTA
3 5782What will be the excat cable specification in Sq MM...please find the details below.... Induction Motor HP:55 Amps:70(starting Amps),45(Running Amps). Volts:415
1 5120How we calculate the current carriying capacity of the different sizes of Aluminium busbar ?
3 11727if the supply voltage increased by N times, the x-section of conductor will be.........
APGenco, Electrical Tech, Ericsson, IES, Thirumalai Chemicals,
2 4837Post New Electrical Engineering Questions
What are the protections for safe running of electric generator?
mccb service sittings be done?
Explain with example of functional requirements of protection relay in terms reliability, selectivity, sensitivity
mostly the questions were from machines... d.c. machines, transformer, synchronous and induction all theory paper........ few from power system... but the level of paper was easy.....
can you plz send l&t aptitude questions if available its urgent plz plz plz
what is the ms flat constant for calculating earth mat design calculation?
why u r living from presentaly working.
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
why output is out of phase in case of common emitter?
Briefing the effects of ASR and ACR of a double closed-loop speed regulating system.
difference between crane drive and line drive.
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
List the power rating of any 5 important electrical appliances used in houses.
how to caculate cable size for diff types of loads? if anyone know the calculating procedure please tell me
what is lumped and distributed elements?