Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between load bearing and non load bearing walls? How to distinguish both?
6 52701why the compressive strength of concrete is calculated only after 28 days.why not after 25, 26,27 days..
7 210551 building project (work in progress) and following are sum detail about his project 1) Using local rebar grade 415 2) Total built up area- 60000 sq.ft 3) Floors to be constructed – 21 storey 4) Estimated requirement of Steel per sq. foot – 7KG/sq.ft 5) Concrete grade – M35 6) Rebars mainly required (sizes)- 16,20,25,32 & (8 mm for stirrups) Wanted to ask u if this person uses 500D…what are the benefits he will be getting? Whether his per Sq. foot consumption can b reduce? If yes den around how much?
1 6270how many days we should curing for plastering,brickwork,concrete?
Al Faraa, Alfaraa, CCCL, Consolidated Construction Consortium Limited, Wipro,
10 73053Post New Civil Engineering Questions
what is escalation?how it is done?
I was once rejected for US visa in early August. But now I'm going again for interview next week. What are the chances that I will faced the same VO????
what is pile and deam foundation
2. In a container filled with each of the following materials, at a porosity of 40%, determine the upward gradient required to cause the quick condition (a) Lead shot with a G = 13.75; (b) Fibre beads with G = 2.15; (c) Sand with a G = 2.32
how to calculate spacing rod in column
how calculate the bearing from two coordinates?
what is Quantity of stone and sand required for one cubic meter of stone work (UCR)
about higyway engineering
what is the tensile strength of 10swg and 8swg gabion wire?
Define What are the reasons for geotechnical site investigations in Uganda?
What is the difference between engineering stress and true stress?
where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?
What is the primary difference between adsorption and absorption?
1. 1. The mass of a chunk of moist soil is 34 Kg and its volume is 0.012 cu. Meter. After drying in an oven, the mass reduces to 14.25 Kg. Determine the water content, the density of moist soil, the dry density, void ratio, porosity and degree of saturation. Take G = 3.25
what is density of 20mm coarse aggregate.plz send answer my below adress e.mail
