As per ratio 1:4:7, how can we calculate the quantity of materials for 1 cum of concreate, pls derive with equation2 3152
If we have the center line of the Finnish road level and we want to know what level of pay would have offset the Lhs and Rhus RHS 1,2.5,5 1,2.5,5 m.670
What is creep ,deflection and shrinkage in concrete3 4487
HOW MANY CEMENT BAGS ARE REQUIRED FOR 1m^2 PLASTERING AREA?1 4882
cement quantity in 1 M3 pcc2 7413
How much permissible bearing capacity requires for open footings(isolated) and what type pile foundatuon prefering for coastal areas?645
HOW CAN I CALCULATE BENTUP BAR'S INCLIND DISTANCE ?2 3970
What is quantity of cement and sand required for 2000sqft of tiling?1457
If a slab concrete is placed with M-20 grade concrete, actually it has to be placed with M-30. what are the rectifications / measures to be taken after concreting is done.
What is the weight of Plunger used in Vicat Apparatus used for testing of cement for knowing standard consistency.How many grams of cement is generally used for this test?
Why we are using 150 mm X 150 mm X 150 mm cubes for testing the compressive strength of concrete in CTM and why not other sizes?
1.Why we are preferring 43 grade cement than 53 grade cement. 2. Approximate cost difference between 43 and 53 grade cement. Thanks.
significance of specific surface area of particles?
i need the syllabus for the direcr recruitement of executive engineers in andhrapradesh
what is derating factor in cable? what does it mean if derating factor is high/low in terms of thermal resistivity of soil?
how much area can be platered by a mason for exterior
why demand factor less then 1 ?
can u plz send me ntpc placement papers(civil engineering) at firstname.lastname@example.org
what is the tensile strength of 10swg and 8swg gabion wire?
Pls provide me with the calculation or codes related to de- shuttering of flat slabs
what are RIB slabs explain about it
PCC Road Min Grade M 30 for VR standard Mahatashtra load 30 KN. what should be thickness of pavement, width 4m what should be length of panel.
In Abutment walls (A1 side) why we are adopting fixed bearing (POT-PTFE)?
Why the finite element method is lower bound solution?
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
how many men days of loburs and masons are requirete for 1 cum,pcc (1:2:4),Pcc(1:3:6) and Pcc(1:4:8) thanking you