why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
1 6853what is difference between RTD , thermo couple and thermistor in general ?? (except temperature co-efficient )
Bilt,
5 17062what is difference between wheatstone bridge, pirani gauge and strain gauge ??? explain its principle and working
4 9742Can we use thermocouple in generator of power station replace RTD(pt 100)? if we don't have any place for use RTD.
2 4612what r all the type of viberation measurement measuring in turbin? what's the output of viberation sensor?
2 6320Post New Instrumentation Questions
Pl send the model question paper of mahagenco account officer post
Draw a wheatstone bridge circuit showing supply, meter and 3 wire RTD connection
what is function of switch, and how is it work, explain with difination
Why even multiple power supplu r used in instrumentation system?
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows very argent : my mai is merajalam143545@yahoo.com
Any body have know try work calculation ???
What is eddy current? Describe the operating principle of proximity probe.
why is not useing in boiler skin thermocople
Gas equation
how to turbine speed measurement?
What is Positive Calibration and Negative Calibration?
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
Which type of pressure can be measured by these elements?
