Why do we have earthing cable in branch cable and shield in the same cable?

2603

detail of mass flow meter pricipal

2299

A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?

1399

pls give me presant awerness quistion and answer in my emailid.

2862

give some question relative instrument fitter?

6263

what are the selections available in configuring a burnout protection of a controller? thanks

1968

What is the use of each wire in three wire RTD

2502

how to calculate signal cable sizing? and multipair cable sizing??explain in brief?

2351

Linear amplifier.

2015

what is output of FOUNDATION FIELD BUS transmitter

2143

What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?

2019

hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com

2562

what is basic difference between motion balance and force balance in pneumatic instrument?

9665

How to convert mmWc(mili meter water colam) to tph(ton per hour)?

981

when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?

1760