What is differance between Slip ring motor and Squirrel cage
Motor ?
Answers were Sorted based on User's Feedback
Answer / d.sanadi
Slipring motor consists wound rotor where as the cage motor
is consists rotor bars connected at ends to form a shape of
squirrel cage.
| Is This Answer Correct ? | 12 Yes | 0 No |
slip ring induction motor and squirrel IM stator both are
same but difference of their rotor circuit slip ring IM
rotor circuit is semi close type. so we are using resistar
in this circuit and give us speed control by rotor
resistance starter.
| Is This Answer Correct ? | 11 Yes | 0 No |
what is FET
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
how moving coil indicator works?
how to calculate knee point voltage for pt?
1. how much normal earth resistance in earth pits(neutral and body earth) and transformer neutral and body earth & panel earth.
12 Answers HP, Malladi Drugs and Pharmaceuticals, Pearl Engineering, PL,
What are the implications when the power factor is is leading condition ?
what is the difference between induction and synchronous motor?explain in simple words?why 3 phase motor is given preference over single phase motor.
In a company the lines carrying 33KV but the load is below 10000Volts so we know that <11KV we can put 11KV lines but the lines are 33KV,..so how we can step down the voltage to 11KV with out erecting a substation
Why are the cores of large transformers built up of circular transactions ?
Types of 132KV and 222 KV protection.
The current though a branch in a linear network is 2A when the input voltage is 10 volts. If the voltage is reduced to 1 volt, and the polarity is reversed, what is the current flowing through the branch ?
why we cant control neutral instead of phase in single phase?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)