Answer / simran

earlier answer was just the full form.
digitally distributed control and monitoring information
system used in thermal pwer plants to centrally control all
the functions without going to the location.

Answer / ram

DDC MIS stands for Digital Distributed control Monitoring
and Information System.The name itself is self
explanatory.Generally used in Power Plants Controls and
Instrumentation.

Answer / naveen chandra shekhar

The microprocessor based distributed digital control,
monitoring & information system(DDCMIS)shall provided
for the safe and efficient operation of SG, TG, balance of
plant and all auxiliaries in all regimes of Operation.

I have a problem with a valve (air to close). When it is fully closed and try to open 1% it doesn't responce till 3% open suddenly more than 3% then back to 3%. I tried to tune positioner then removed it, the problem still exist. Any idea

3 Answers  

---

What is the function of SMPS

2 Answers  

---

Transducer Input 0 to 230 v ac Output-0 to 10vdc Receiver Input 0 to 10 vdc and Output 4 to 20 ma How?

1 Answers  

---

Any can guide for QA/QC Inspector in oil & gas region, the procedures, formats standards, design criteria, i search in all enginees but i can't found wat i need?????????

4 Answers   Aramco, Asian Paints,

---

How to convert ma to mv? Resistance 250 ohm is connected in series or Parallel?

3 Answers   ISRO,

---

How can corrosion alter the accuracy and precision of a C- Bourdon tube pressure gauge?

1 Answers  

---

Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards?)

1 Answers  

---

generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?

1 Answers  

---

Ple give me "INDUSTRIAL INSTRUMENTATION AND CONTROL S.k. Singh 3th edition" Solution manual to self-Check Quiz and chapter-wise PowerPoint Slides. Home web-site not available... Ple Ple Ple Ple Ple Ple Ple Ple Ple Ple Ple Ple Ple Ple Ple Thanks for all...

0 Answers  

---

what is air to open and air to close control valve and difference btwn this...and how to measure milli amp by this...and what is the role of positioner and i/p converter in this..plz help me

2 Answers   HCL, SOC,

---

what is mapping in instrumentation and control engineering

2 Answers  

---

how to calibrate differential pressure switch

2 Answers  

---