Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards

Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards?)

Question Posted / yusuf

1 Answers
3373 Views
I also Faced
E-Mail Answers

Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards?)..

Answer / gautam

I/o card

Is This Answer Correct ?

4 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

WHY WE WILL USE 0-24VdC IN ELECTRONIC CIRCUITS AND INSTRUMENTATION TRANSMITTERS?

3 Answers Aban Power, Jindal, JSW, Sugar Factory,

why we connect digital multimeter in series for dc current measurement and parallel for dc voltage measurement.

4 Answers

What is meant by calibration

5 Answers

why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.

0 Answers ONGC,

Ohm’s law, kirchoff’s law, pascal’s law, Bernoulli’s therem,

1 Answers CCIE, Emcure,

in the boiler in the main steam line and its bypass line and the startup vent vales are only motorised valves why cant we use other types of valves such as pneumatic.

3 Answers

Questions on flow meters,few questions on HART protocol,

0 Answers Monnet,

Explain level troll principle & interface level measurement.

1 Answers ADMA OPCO,

plz send me general of ongc

0 Answers ONGC,

why do 4 mA serves as 0% not 0 mA?

10 Answers

Explain Split Range Control In Control Valve Briefly.

5 Answers

Give 2 application of quartz crystal used for process parameter measurement.

0 Answers ADMA OPCO,

For more Instrumentation Interview Questions Click Here