I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY
INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM
INTERVIEWER?
No Answer is Posted For this Question
Be the First to Post Answer
What is the function of the auto reclosure relay?
At what voltage domestic tubelight works?
what is the difference between RMS & TRUE RMS VOLTAGE
what is power load and lighiting load?
what is the working of ups.
What is the function of UV coil ACB?
A 60w bulb & a room heater are connected in series.if 60 w bulb is replaced by 100w then what will be the effect on heater out & why?
What is the RMS Value. Please discribe in detail
Ohm's law applicable for semi-conductors?
HOW TO CALCULATE THE APFC Panel Design
I have 11KV/415V power distribution transformer. I have found unbalance current in LT (415V) side. Also observed that unbalance voltage (3V) at LV side due to HV side unbalance voltage. What should I check for this? Also, the same LV side load can run in balance on captive power.
why neutral busbar size is half of the phase busbar size in control panels
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)