Answer / sandeep meena

because of humidity dependence on geographical condition
like temperature and presure.

Answer / murthy

relative humidity is relative measure of humid conditions
to that saturated humidity,so it varies with location it is
measured, because variation of saturated humidity.for eg
near sea there will be higher relative humidity , where as
in desert areas lower relative humidities

Answer / barsha

because of water vapour as some places have higher water vapour and some places have lower

Define pneumatic conveying?

0 Answers  

---

What are the effects of oils on the properties of Polyolefins?

0 Answers   IOCL,

---

How can separation of chiral chemicals affect the chemical and/or pharmaceutical industries?

0 Answers  

---

what are the chemicals used in PFR and MFR to Process?

0 Answers  

---

POLYMER ENGINEERING - QUESTION 24.1 : The molecular weights M in kg / mol of 3 different monomers a, b and c in a polymer are Ma = 14, Mb = 16 and Mc = 18. The fraction of polymer chain X of 3 different monomers a, b and c in a polymer are Xa = 0.5, Xb = 0.3 and Xc = 0.2. (i) Calculate number average molecular weight by using the formula Ma Xa + Mb Xb + Mc Xc. (ii) Calculate weight average molecular weight by using the formula (Ma Xa Ma + Mb Xb Mb + Mc Xc Mc) / (Ma Xa + Mb Xb + Mc Xc). (iii) Calculate the polydispersity by using the answer in (ii) divided by answer in (i). (iv) If the molecular weight of repeat unit is 12, calculate the degree of polymerization by using the formula (Ma Xa + Mb Xb + Mc Xc) / (molecular weight of repeat unit).

1 Answers  

---

ENGINEERING MATHEMATICS - EXAMPLE 8.2 : In the US (United States), one barrel is equal to 42 US gallons and equivalent to 0.15898 cubic metres. One British barrel is equal to 36 Imperial gallons and equivalent to 0.163659 cubic metres. If an oil refinery in England sells 42 Imperial gallons of crude oil to a company in US, how much US gallons of crude oils has been sold?

1 Answers  

---

PETROLEUM ENGINEERING - QUESTION 25.1 : Fact 1 : Dry air contains 20.95 % oxygen, 78.09 % nitrogen, 0.93 % argon, 0.039 % carbon dioxide, and small amounts of other gases by volume. Fact 2 : Volume occupied is directly proportional to the number of moles for ideal gases at constant temperature and pressure. Fact 3 : 12.5 moles of pure oxygen is required to completely burn 1 mole of pure octane. Fact 4 : Air-fuel ratio (AFR) is the mass ratio of dry air to fuel present in a combustion process such as in an internal combustion engine or industrial furnace. Fact 5 : Molecular weight of oxygen gas is 31.998 g / mole and molecular weight of nitrogen gas is 28.014 g / mole. (a) Find the molar ratio of nitrogen and oxygen, or (moles of nitrogen) / (moles of oxygen) in dry air, by assuming ideal features of nitrogen and oxygen gases. (b) How many moles of nitrogen are available if dry air is used to completely burn the 1 mole pure octane? (c) Find the mass of fuel of 1 mole of octane with molecular weight of 114.232 g / mole. (d) Find the mass of dry air with 12.5 moles of pure oxygen by assuming only oxygen and nitrogen gases exist in the air. (e) Find the air-fuel ratio (AFR) when octane is used as fuel. (f) Find the fuel-air ratio (FAR) when octane is used as fuel.

1 Answers  

---

CHEMICAL ENERGY BALANCE - EXAMPLE 11.5 : According to Margules Equation, P = x(1) p(1) g(1) + x(2) p(2) g(2) for a two-component mixture where P is bubble pressure, x is mole fraction, p is saturation pressure, g is constant given by ln g(1) = x(2) A x(2). Find the value of A as a constant when P = 1.08 bar, p(1) = 0.82 bar, p(2) = 1.93 bar in a 50 : 50 mole fraction mixture. Estimate the pressure required to completely liquefy the 30 : 70 mixture using the same equation, by proving P = 1.39 bar. Take note that ln g(2) = x(1) A x(1), ln g(1) = x(2) A x(2).

1 Answers  

---

What types of valves are recommended for slurry services?

0 Answers  

---

what is the difference between car seal close/open valves and lock close/open valves?

0 Answers   MNC,

---

Are there flow velocity restrictions to avoid static charge build up in pipelines?

0 Answers  

---

What is control valve ?

2 Answers   TCL,

---