How can I communicate with an Areva MiCOM P121 relay by RS485 port? In other w

How can I communicate with an Areva MiCOM P121 relay by
RS485 port? In other word, which command can I send and
what information can I have recieved? please send some
refrences, please. thanks

Question Posted / mohammad koochi

3 Answers
9242 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

How can I communicate with an Areva MiCOM P121 relay by RS485 port? In other word, which command c..

Answer / nur.asidik

all micom series compatible for mudbus RS485 as basic communication protocol,

Is This Answer Correct ?

0 Yes

0 No

How can I communicate with an Areva MiCOM P121 relay by RS485 port? In other word, which command c..

Answer / fajar

ow can I communicate with an Areva MiCOM P121 relay by
RS485 port? In other word, which command can I send and
what information can I have recieved? please send some
refrences, please. thanks

Is This Answer Correct ?

0 Yes

2 No

How can I communicate with an Areva MiCOM P121 relay by RS485 port? In other word, which command c..

Answer / shayan

hi please email me your question.if you find your way for
connection to p121 please say to me.
do you know what is your relay protocol?

Is This Answer Correct ?

2 Yes

6 No

Post New Answer

More Electrical Engineering Interview Questions

DC Motors applications used in Lift/Elevators

8 Answers IOCL, SCS, Usha Martin,

How time response of the system is divided?

0 Answers

i have need all detail above basic transformer question..

0 Answers

i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.

0 Answers

how we are measuring the winding temperature of the transformer?

11 Answers

in 132 kv transformer , in which range of transformer oil bdv required ? if it has around 50-55 , then how it was insulated the winding ?

3 Answers Voltamp,

what is difference between AC VVVF drive & Dc VVVF drive explain their working principle?

13 Answers Apollo, OPS,

One 200 V, 100 W bulb is connected in series with primary of a 200 V, 10 kVA transformer. If its secondary is kept open circuited, then the bulb would have (1) Full brightness (2) Poor brightness (3) A little less than full brightness (4) More than full brightness...explain

2 Answers

Why AC loads wont used in DC input supply? and Why DC loads wont used in AC input supply?

3 Answers Bhel,

How to decide the size of the capacitor for a single phase induction motor say 2 HP ??

0 Answers

When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number

0 Answers TATA,

Which supply is using for train AC or DC & what is the voltage????????

16 Answers

For more Electrical Engineering Interview Questions Click Here