Answer / plani swami

Within this 3 Months.

Answer / babu

same question to me also if u ahve any idea plse send the
details to realrao@in.com

transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?

0 Answers   Bhel,

---

how the voltage between all the three phase is zero can any body explain me

5 Answers  

---

how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???

0 Answers  

---

How big (size) can the tertiary winding be in transformer? Can we load the tertiary winding, if yes then how much we can load it?

1 Answers  

---

What is the Resposiblity of Electrical Utility Engineer

0 Answers  

---

difference between high and low impedance BUS BAR relay??

0 Answers  

---

What is the difference between analogue electronics and digital electronics?

2 Answers   PSU,

---

Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)

0 Answers   UOG,

---

what is the power factor

13 Answers   Heidelberge Cement,

---

can u describe the method used for protection of transmission line.

0 Answers   IBM,

---

What is EPBX????

3 Answers   Emerson,

---

how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.

0 Answers   OPS,

---