i have applied for junior engineer 2 c&w for Guwahati RRB
please send me last five year question paper
No Answer is Posted For this Question
Be the First to Post Answer
what is different between DIGITAL and ANALOG?
what happens if i connect acapacitor to a generator load
Why neutral wire is heating in symmetric single phase distribution of three phase power supply?
we have taken HV test of 2.5 k and Megger test on 11 kv HT cable.here it shows no fault but when we are charging the same cable with 11 kv supply why the VCB 11 kv gets tripped can anybody define the possible cause of fault ?
what are the analog quality input for protection function?what are minimum reqiments?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Explain how you intend to work under pressure to meet up with deadline target?
How to set a Zone 1 distance relay for distribution feeder?
0 Answers Schweitzer Engineering,
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
What is the principle of Excitation.
why pure sine wave inverter used for desktop ?
Our Company's Contract Demand is 110 kVA. We use 12 Capacitors each of 12.5 kVAr Capacity to maintain Power Factor of 0.99. So, what steps should we take so that our Contract demand does not exceed 110 kVA?