what is the diff. b/w balanced and unbalanced load..?

Answers were Sorted based on User's Feedback



what is the diff. b/w balanced and unbalanced load..?..

Answer / vividha

spcl attention is needed in unbalanced load
but in balanced load need of attention is not required

Is This Answer Correct ?    0 Yes 0 No

what is the diff. b/w balanced and unbalanced load..?..

Answer / rishabh jadia

In 3 phase balanced supply, 3 phase have
equal amplitude and frequency with each phase
difference.
but
In 3 phase unbalanced supply. 3 phase have
either equal or unequal frequency with each
phase....

Is This Answer Correct ?    3 Yes 5 No

Post New Answer

More Electrical Engineering Interview Questions

In all the generators, the excitation supply is DC. What is the significance of DC excitation? What will happen if AC supply is given as excitation supply?

8 Answers  


why we can't use more then 50 hz in india ? Is it possible ?

7 Answers   DVC,


how can we rotate a single phase motor (without cap.)in reverse direction?

2 Answers  


How many VSC based HVDC are there in India and the world

0 Answers  


how load of a turbo generator can be increased

0 Answers  






What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw

0 Answers  


I have 320 Kva DG Set his KWh running is 77 , how i can calculate into electrical unit .

2 Answers   Anuj Enterprises, Schneider,


for 1000kva transformer how kvar rating is need for this PFI plant. and how does it will calculate? and Apmpere rating of main cable connection?

6 Answers   Engineers India, GCC, KP, QPSL, Siemens,


10Hp, 3-phase, 415v, 50Hz induction motor. The above motor is to run on Star-Delta connection, so how do i make following hardware selection 1) MCB, 2) Contactor, 3) Wire Gage (Depending on P-P current or Line Current), 4) OLR, Please tell in detail how to do the above, so as to get the ans. of it even if the Hp rating changes.

1 Answers   Engro,


Why distribution transformer secondary voltage is 0.433kV instead of 0.415kV.all other switchgear rating are 415 volt??

3 Answers  


What is the better way of passing 400 amp from sending end to receiving end ? By overhead line or underground cable and why ? if underground cable then how much depth require ?

1 Answers   Aditya Birla, HCL,


What is the difference between Generator Differential Relay and Transformer Differential Relay?

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)