Why the isolation treasforfer are connected at out put of
the ups ig 200kva ??????????????????
Answers were Sorted based on User's Feedback
Answer / prasun bhaumik
To isolate the neutral so eliminate the effect of neutral
shifting voltage at output
Is This Answer Correct ? | 1 Yes | 1 No |
can a rotating machine give the DC output without commutator? if yes, how? if no, why?
Can any answer me ,What will be the range of C.T coil for L&T energy meter EM301 used for 180 kva DG set
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
CAN CU XLPE/PVC CABLE BE USED INPLACE OF LOW NOISE SCREENED CABLE? KINDLY GIVE REASONS
in a delta-star with neutral grounding on star side what will happen if one star limb got opened at star point
How the value of KVAR of capacitor bank used in switchgears calculated??
which one is rotating transformer-single phase induction motor or 3 phase squirrel cage motor?
Why are lt windings placed near the core?
How i can calculate the cable size for given load,there is any formula,for 3 phase and single phase
2 Answers Prescient Technologies,
why 120 devided with pole and speed multiplication to determine frequency
How can we calculate the fault level of the distribution system knowing the percentage impedance of transformer & subsequent equipments.
I have a transformer whose primary operates at 230V, 50Hz for which the secondary voltage will be 12V, 50Hz. What will be the secondary voltage if the primary is fed with 400V, 8KHZ Signal?