which cycle use in thermal power plant?
Answers were Sorted based on User's Feedback
Answer / vishwakarma
rankine cycle is used in thermal power plant(steam)
but in gas power plants brayton cycle is used
process involved in both are same
ie const pressure heat add and rejection
alongwith isentropic exp and comp
but complicasy arises in rankine cycle due to use of steam
as it exist in diffrent states(liq, vapour)
Is This Answer Correct ? | 23 Yes | 3 No |
Answer / ravi kumar
reheat & regenrative cycle is used because its efficiency
is moire than rankine cycle .today few power plants uses
brayton cycle in us & other forign country.
Is This Answer Correct ? | 10 Yes | 5 No |
Answer / m.rajesh
Rankine Cyle
few power plant using reheat & Regenrative cycle
Is This Answer Correct ? | 5 Yes | 2 No |
Answer / neeraj kumar mehta
The thermal power plant using a reheating-and-regenerating
type Rankine cycle.
Is This Answer Correct ? | 4 Yes | 2 No |
Answer / prabhakararao
rankine cycle used in thermal power plants brayton cycle
used in gas turbine power plants
Is This Answer Correct ? | 2 Yes | 0 No |
Answer / sushil moon
Rankine Cycle is used because its efficiency is more and
efficiency is more because temperature generated in Rankine
Cycle is more.
Is This Answer Correct ? | 1 Yes | 0 No |
generally in reaction turbine, only a part of pressure energy is converted into kinetic energy. whaat about balance pressure energy incase of single cylinder steam turbine?
WHAT IS A TR REQUIRED IF AIR FLOW 6500 CMH COIL INLET TEMP 7 - 12 DEGREE C AIR TEMP INLET - 18 DEGREE C & REQUIRED TEMP IS 12 DEGREE C
Which factors influence the type of fracture in failure of a material ?
• What kind of person would you refuse to work with?
Why an increase in area is required to produce an increase of velocity in case of supersonic flow ?
The old welding machines used electromagnetic winding to step up the current for welding rods. What is the new principle inside the welding machines?
4 Answers Bharat Gears, Focus, Focus Energy,
hi this is ravi , i was short listed in hal assistant engineer, now im going for interview can anybody help how is the interview for mechanical stream very urgent if anybody knows forward to me my mail id i.ravibabu2@gmail.com
In terms of electrical enhineering, give a detailed explanation of the "earth fault loop path"
0 Answers National Engineering Industries, NTPC,
If a dimension is given as SC parameter, is supplier allowed to use full range of tolerance specified in drawing without proving capability?
wht will happen if reciprocating compressor run in exactly opposite direction?
What are considerations taken into account while creating a piston head?
I have 1010 KVA Generator when i run the DG set for 5 to 6 hours the couplling (couplling joint in between engine & alternator) bolts are getting loose what is the reason & what is the remedy over this??????????