what is bus pt and what is the function of it
Answers were Sorted based on User's Feedback
Answer / irfan khan
pt is the pottential transformer which uesd for measurement
of voltage as well as control supply also.the high voltage
can not be measure directily , e.g. incomer voltage is 132
kv so we put the bus pt of 132kv/1.732/110 volt /1.732 for
6.6 kv voltage measurement . the voltage of primarry and
seconderry may be vary acordingly.gernelly the seconderry
of pt voltage is 110 volt or 220 volt AC. so seconderry
voltage can be used measurement as well as protection.
| Is This Answer Correct ? | 6 Yes | 0 No |
Answer / ashish
bus pt is control transformer which are required for
circuit control.because we can't use the high voltage in
control circuit.
| Is This Answer Correct ? | 2 Yes | 2 No |
why the neutral point in connnection oscillates?
Why primary batteries not rechargeable and secondary batteries are rechargeble??? If any one know please send me.
What Maximam Gap Taibaar & Bush
A 100 kVA , 400 v/250 kv testing transformer has 8% leakage reactance and resistance on 100 KVA base . A cable has to be tested at 500 kv using the above transformer as a resonant transformer at 50 hz . if the charging current of the cable at 500 kv is 0.4 A find the series inductance required . Assume 2% resistance for the inductor to be used and the connecting leads . Neglect dielectric loss of hte cable . what will be the input voltage to the transformer ?
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
if my load is not in continuous operation so what type of panel is required APFC or fixed capacitor bank without APFC whether C.T is required in both cases compulsory? explain detail
What is difference between Dy11 & Dyn11 vector group transformer. Can both these transformers operate in parrallel.
Why is voltage is required to be within permissible range for an electrical equipment?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
what is pilot wire? what is the use of pilot wires?
what happen if power factor goss to above unity (one) ? of any electrical system or motor.
a 25kvar capacitor bank connected to the secondary side of transformer.then why the capacitor draws more current then rated
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)