What is surger vector in 33Kv transmission feeder? We have
AC power generator of 8MW which is paralleled with 33Kv EB
grid. Some times our HT breaker gets trip off due to surge
vector problem. How to over come it? Is there any device to
observe the surge and avoid tripping?
Answers were Sorted based on User's Feedback
Answer / rajendran
I think the question is about the vector surges in the
transmission lines....
These surges are sharp dips in the quantity of the
transmission lines happening due to the severe loading or
faults in the transmission lines...
usually when the generators are connected in parrellel
with the grid it will be provideed with the VSR protection
inorder to avoid the overlaoding of the generator during
the micro second grid failures (during the vectro surge)...
We can not eliminate the inherent surges in the
transmission lines....
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / senthil
this phenomena is called as vector surge, for examole line
is closed with out checking synchrnous , so due to
unbalance disturbance may happen, this can be sensed by
fixing vector surge relay
| Is This Answer Correct ? | 1 Yes | 1 No |
Answer / prem
you can use an M#3 relay for vector surge protection....
it is quiet useful and a little bit problamatis in programming
| Is This Answer Correct ? | 0 Yes | 0 No |
what are safety measures in /control in diesal engine/ explain them?
How to measure current and voltage in an ELV circuit
what is the use of Reactive power in power system?
If a generator of generating station produces 100MW rated output then what will be the rating of the step-up transformer connected to it?
what can i do, if i want to carrier in design as i am electrical engg?
WHY DOES NEUTRAL DO NOT CARRY EVEN THOUGH IT CARRIES RETURN CURRENT?
what is meant by reactive power ?
hi... Can anybody give me description of type-2 coordination, IP protection, NEMA standards ? Thanks..
how to distinguish between ac motor and dc motor without seeing name plate of it.only seeing its getup look
Can we use droop CT in neutral in place of W phase of alternator ?
how to calculate the power factor when instantaneous voltage and current has harmonics in it ?
how 650 volts creates? where is use?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)