What is surger vector in 33Kv transmission feeder? We have
AC power generator of 8MW which is paralleled with 33Kv EB
grid. Some times our HT breaker gets trip off due to surge
vector problem. How to over come it? Is there any device to
observe the surge and avoid tripping?
- 3 Answers
- 6661 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajendran
I think the question is about the vector surges in the
transmission lines....
These surges are sharp dips in the quantity of the
transmission lines happening due to the severe loading or
faults in the transmission lines...
usually when the generators are connected in parrellel
with the grid it will be provideed with the VSR protection
inorder to avoid the overlaoding of the generator during
the micro second grid failures (during the vectro surge)...
We can not eliminate the inherent surges in the
transmission lines....
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is the type of feedback used in an op- amp schmitt trigger?
Formulae for calculating the transmission line losses for different voltage levels
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
what is sevice settings for mccb?How can be it setted?
what is the major difference between LIBBP & HIBBP.. which one is most preferable..
what is the minimum winding resistance of 30hp compressor, to run or to switch on
what is the difference between fault current ant short circuit current?
how to test power transformer.YNd11
Dear sir, I have completed DECE in the year 1995. I have work experience in HT and LT LINE more than five years. Now i am doing BE in EEE from rajasthan university. After completion of BE,can i apply "C" Licence sir? Please reply.
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
What is real time power factor control panel(RTPFC)?
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
What will be in Mahagenco Trade Test Exam? I want to know the same.
difference between crane drive and line drive.
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
