Answer / edward411

that's the minimum loop resistance needed to communicate
via hart protocol u exeed the value it will still work

Answer / kirti

for reduces current flow

Answer / satya

for thermocouple compansation

If the average power during generation is zero, why do the analog meters have + and - ?

1 Answers   Siemens,

---

Can anybody explain what is the different between ESD & PLC

1 Answers   ADCO,

---

how many parts of valve positioner?

1 Answers   Kentz,

---

Why we are using thrust bearing at turbine side?

3 Answers   Edac,

---

There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?

0 Answers  

---

What should be the stanchan Height for installation of Smoke detector & toxic gas detector in field,according to qatar standard

2 Answers  

---

what is control valve input and out put

10 Answers   Nirma,

---

what are the values of fuel flow rate in various places in boiler.

0 Answers  

---

which type of rtd is good for any system,2wire,3wire or 4 wire

9 Answers  

---

I am using Capacitive type level transmitter for measuring oil level in a closed tank (lub oil tank). The txs range is 1500mm, and they do hunt regularly (for about 45mm), can anybody tell what could be the reason??? or any other type level tx that could be used to avoid this?

1 Answers  

---

in the flow caluclation k value how to caluclate.mass flow & volum flow.

1 Answers  

---

how eddy current loss in probe and induced gap voltage accros probe trip and shaft

1 Answers   Reliance,

---