Are fin tubes necessary for steam heating a liquid?

7 Answers   IOCL,

---

motor vs pump

1 Answers   Inogent Laboratories,

---

what is the purpose of capacitor? and capacitor load means what? how does it connect?

0 Answers  

---

Question 72 - (a) According to United States Department of Agriculture (USDA) (http://ndb.nal.usda.gov/ndb/search/list, accessed 12 August 2016), 100 g of potatoes generate 77 kcal of energy. For raw tomatoes, 111 g have 18 kcal of energy. Question : How much energy will one gain if 150 g of heated potatoes are eaten with 200 g of raw tomatoes? (b) If 1 Calorie = 1 food Calorie = 1 kilocalorie and 1000 calories = 1 food Calorie, then how many Calories are there in 9600 calories? (c) According to a food package of potato chips, 210 Calories are produced per serving size of 34 g. In actual experiment of food calorimetry lab, 1.75 g of potato chips, when burnt, will produce 9.6 Calories. For each serving size of potato chip, find the difference of Calories between the actual experimental value and the value stated on the food package. (d) The specific heat of water is c = 1 cal / (g.K) where cal is calory, g is gram and K is Kelvin. Then what is the temperature rise of water, in degree Celsius, when 150 g of water is heated by 9600 calories of burning food?

1 Answers  

---

Question 59 – There are 5 simultaneous equations with 5 unknowns as follow : 16 V – 4 X – Z = 36, 4 X – 4 W – Y + Z = 3, 8 V + 4 W – X + Y = 10, X – W = 1, V + W = 0. Find the values of V, W, X, Y and Z accurately within 15 minutes. State the computer program that you use to get the answers.

1 Answers  

---

pls send me model paper of NPCIL for executive trainee. and syllabus of executive trainee 2015.

0 Answers  

---

What are advantages using hollow shaft impeller?

0 Answers  

---

UNIT OPERATION - EXAMPLE 9.1 : Which of the sequence below represent a feasible flows of ethanol processing plants using cellulose as starting material? A. raw material -> heat exchanger -> distillation column -> reactor. B. reactor -> distillation column -> raw material -> heat exchanger. C. heat exchanger -> raw material -> distillation column -> reactor. D. raw material -> heat exchanger -> reactor -> distillation column. E. distillation column -> raw material -> reactor -> heat exchanger.

1 Answers  

---

MASS TRANSFER - EXAMPLE 4.2 : In a non-dilute absorber, graphical method is used to represent the process. In an X - Y coordinate system, X-axis represents mole of carbon dioxide / mole of water and Y axis represents mole of carbon dioxide / mole of nitrogen. The inlet gas stream consists of 8 mol % of carbon dioxide in nitrogen. (a) Find the S / G minimum as a slope that goes through the point (0, 0.0304) and (0.0000488, 0.086957). (b) Find the actual slope of operating line when it is 1.5 times the S / G minimum! (c) Find the value of x for inlet gas stream when y = 1640 x, y is mole fraction of carbon dioxide in nitrogen.

1 Answers  

---

what is the melting point of ash?what is value of ash in crude oil?

1 Answers  

---

Explain the different ways in which solids can be blended?

0 Answers  

---

how interstage pressure of multistage compressor is calculated?

2 Answers  

---