PID controller is used for which type of compensation……
a) lead comp. b) lag com. c) lead lag com.
Answers were Sorted based on User's Feedback
Answer / dileep mishra
PID - Proportional integral & derivative
control modes of PID
1) on\off control
2) proportional control
3) proportional integral control
4) proportional derivative control
5) proportional integral & derivative control
| Is This Answer Correct ? | 13 Yes | 27 No |
What is force balance principle? State some of its’ advantages.
What is the difference between a PLC (Programmable logic controller) and DCS (distributed control system)?
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
TECHNICAL/ARTITUDE
How to calibrate smoke Dectector
What the basic of communication?
How much voltage we are using at switches?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
open tank and close tank leavel transmiter about range and calibration
Why we use DPT? can we use PT instead of DPT?
How to rerange a dp type level transmitter after installation?
why we are using negative range like -750 to 0 mmwc in closed tank?and what is the reason can you explain clear?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)