Why capacitive banks ar5e important?
Answers were Sorted based on User's Feedback
Answer / pasuvaraj
To increase the power factor & reduce the Harmonics
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / pranjal senjaliya
not increase the P.f. buy we can say to improve the p.f. &
supress the harmonics which is produced by mainy by dc
loads.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / earnest
To improve p.f. thereby reducing reactive power.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / pankaj dubey
a capacitor bank also called as filter for supress
harmonics in the system this is ans for drive or rectifier
capacitor bank
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / sudesh
It reduces system losses and also improves power factor.
| Is This Answer Correct ? | 0 Yes | 0 No |
1.what is beta in control valves? 2.what is the condition followed by light in LASERs? 3.1kg/cm2=?psi 4.Integral action reduces what? 5.about vena contracta 6.a simple RC circuit 7.thermistor material's temp coefficient of resistance 8.if wave passes through the thicker area of a chord to a thinner area what changes will occur to wavelength? 9.if 4-20 mA represents 0-10 kg/cm2 what will be the current when pressure is 5 kg/cm2.................
There are many type of control cable like pair,core,tried, What are defination each one
Please why do we use 4-20ma in instrumentation engineering
in DCS or PLC we can not put all ai or di,there is calculation through which we can accomodate certain no of digital and analog signal.I need to know that calculation
How INtools is useful for routine Instrument maintenance?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
Why integral control mode call Reset controller?
what master plc do?
what is the differnt between open loop and close loop ?
Calibration procedure for Electro magnetic Flow meter
What is Actuator?
How to Calibrate Temperature Switch in field
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)