Answer Posted / pranjal senjaliya
not increase the P.f. buy we can say to improve the p.f. &
supress the harmonics which is produced by mainy by dc
loads.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
Q1: Consider part of a control loop, which excludes the transmitter, consisting of a process, a controller and a control valve which may be represented by two dead times of 0.5 min each and three exponential lags of 0.8 min., 1.0 min. and 1.5 min. respectively. We wish to express this system as an overall first order plus dead time (FOPLD) model ie gain, time constant and process dead time. (We will see later that this is often done, to simplify controller tuning). For this exercise, gain is considered to be 1.0. (A) If the transmitter is a flow transmitter whose behaviour can be described by a dead time of 0.2 min. and an exponential lag of 0.5 min. in terms of the overall dead time and overall first order lag how can the system behaviour be approximated ? Overall dead time = Overall time constant = (B) If the transmitter is a temperature transmitter with a temperature sensor in a protecting well whose behaviour can be described by a dead time of 0.7 min. and an exponential lag of 15 min. how can the overall system behaviour be approximated now? Overall dead time = Overall time constant =
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
How to Calibrate Coriolis Flow transmitter in field
Hi, Is there any smart plant instrumentation design training institute in Bangalore?
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
How do you identify an orifice in the pipeline?
What is rang ability?
DEAR SIR/MADAM MY NAME IS ARKAPROVA BHATTACHARYYA.I AM A FRESHER INSTRUMENTATION ENGINEER.CAN YOU PLEASE SEND SOME QUESTION PAPERS OF GRADUATE ENGINEER TRAINEE EXAM OF DVC(DAMODAR VALLY CORPORATION).MY EMAIL IDs ARE arka_aec@rediffmail.com.
What is the procedure of calibration of Load cell?
How flow can be measured with dp?
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
What is cut off relay? And why use in PLC and DCS?
I need to know steps to Calibration Valve Guard......
What is the exact differences between HART,FOUNDATION FIELDBUS,PROFIBUS?
