What are the Safety measures in central chiller plant?
Explain them?
- 22 Answers
- 60859 Views
- Carrier, CPIC, HSL, JLL, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / sudeep
1)Refrigerent Discharge pressure high
(2)Refrigerent Discharge temp. high
(3)Condensar water flow fail.
(4)Chiller water flow fail.
(5)Oil Discharge pressure low.
(6)Compressure motor trip. low & high voltage..
(7)Antifreeze
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / de3epak
1.High presser
2.Low pressure
3.Oil pressure
4.Anti Freezer
5.Water Flow Switch
6.Pressure relief valve
Is This Answer Correct ? 0 Yes 0 No submit
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / anand kumar singh
(1)- Evprotor low temp.
(2)- condesor high temp.
(3)- low pressure.
(4)- high pressure.
(5)- Refrigerant level
(6)- oil level.
(7)- Flow switch
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / sunil kumar
1.High presser
2.Low pressure
3.Oil pressure
4.Anti Freezer
5.Water Flow Switch
6.Pressure relief valve
| Is This Answer Correct ? | 3 Yes | 0 No |
Answer / deepak kumar
high pressure low pressure cutout
# high tem. Low tem. Cutout
# pressure release valve
# Solenoide valve
# Expansion valve
# flow switch
| Is This Answer Correct ? | 2 Yes | 0 No |
High pressure controller switch.
Low pressure controller switch.
Low oil pressure.
Anti freeze.
Water flow switch.
Fusial plug.
Pressure relief valve
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / faisal
High pressure
Low pressure
Balancing valve
Motorise valve
Oil temperature
Aqumelater
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / jaheer hussain
hp,lp,oil pressure regulator switch,antifreez thermostate,waterflow switch,voltage monitor
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / manish yadav
High pressure (head pressure)
Low pressure
Water flow switch
Anti frezier
Oil pressure
Over load relay
| Is This Answer Correct ? | 1 Yes | 0 No |
How to Calculate The Neutral Earth flat design calculation for the Synchronised generator (Gen 1-650Kva, Gen 2-725Kva
what causes contact chatter when there is no demand on the air conditioning unit?
role of shunt coil in circuit breakers
Make a list observation on Transformer?
expalanation for 5p10 class.
what is difference betwen genrator and alternator?
Can RCD's used to protect the VVVF drive if not why.
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor frequency at maximum torque point is A 3.33% B 4.44% C 5.55% D 6.66%
why is the number of turns different in current and potential coils of wattmeter..?
What is the general power factor & min. power rating of TV,LCD type TV, CRt type TV, Scanner, printer?
How cable from Kit-Kat to main switch, from starter to motor are designed?
which motor is suitable for traction? why?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
