What power factor maintain you maintain at u r organisation

Question Posted / guest

14 Answers
21142 Views
Wheels India, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What power factor maintain you maintain at u r organisation..

Answer / prince

.99

Is This Answer Correct ?

0 Yes

0 No

What power factor maintain you maintain at u r organisation..

Answer / william lobo

Well so many answers to this simple question. The real
answer as per my experience is 0.85 to 0.9. The minimum
requirement by the Electricity boards is 0.8 to 0.85 or
they will charge a fine. But for industry 0.85 to 0.9 is
optimum and above this you will have to use large capacity
of Capacitor banks which is not practical. Also if
capacitors are too many than this will give leading PF and
this is not good since this leads to higher voltage and
many times has resulted in motor burning or failures, and
permature failure of electical equipment.

Is This Answer Correct ?

0 Yes

1 No

What power factor maintain you maintain at u r organisation..

Answer / lakshmi shankar pathak

in the industry usually the load is inductive.so i will try to maintain the power factor in the range of .6 to .85

Is This Answer Correct ?

1 Yes

3 No

What power factor maintain you maintain at u r organisation..

Answer / suthan prabhu

for industrial load we have to maintain 0.8 to 0.85 p.f

Is This Answer Correct ?

1 Yes

4 No

Post New Answer

More Electrical Engineering Interview Questions

whats the advandage of PMG in alternator?

2 Answers

i need bhel question papers.

5 Answers Bhel,

if 15 kv is grounding directly what will happen?

5 Answers

If u take a kWh reading in 11 kV HT and 440 LV side at same time in yesterday today , then why LT consumed units 3-4℅ high as compared to HT units

1 Answers Brigade,

what is the necessary of using inductance property in transmission lines even through resistance is used to opposes the high current flows in that?????

0 Answers

How to justify this statement ??? "Capacitors in series provide less capacitance but higher voltage breakdown rating for the combination"

0 Answers

If single phase having 220v so why 3phase is440v.

7 Answers DLF,

what is Basic Engineering.,FEED and Detail Engineering with respect to Electrical Engineering.(Explain with Example)

1 Answers

what's the reson that,Load is not same on VFD I/P and O/P Side.whenever DOL condition load is same I/P and O/P side.

1 Answers

What is In (current rating) shown on the MCCB? Is this full load which can withstand by the circuit breaker

4 Answers

what happen for input voltage output voltage input current output current and kva if we increase primery winding in transformer?

1 Answers

How to test Power Transfomer vector group?

1 Answers Bhel,

For more Electrical Engineering Interview Questions Click Here