Answer / naveen singhal

Check the diode by multimeter. If check the dc voltage
between anode and cathode , value is 0.7 V. and then change
the lead of multimeter on diode terminal check , value
should be come zero.

Answer / dhiraj

it's not the write question..........
if u want to check the doide check its continuty by
multimeter........

what is surge??

1 Answers  

---

What will happen if 40W and 60W Bulb is Connected in Series.

2 Answers  

---

what is need of air gap in expansion section in busbar?

3 Answers  

---

How you calculating the current for a 2.5 Sqmm cable. A 30 Hp 3 phase AC motor of power what size of cable is used for this motor.

7 Answers   Siemens,

---

What is servo motor and what are different types of servo motor

0 Answers   BARC, Vipul,

---

How can we calculate C10 rating of a bttery from c5 or c20 ratings??

1 Answers   Intel,

---

What is the maximum breakdown voltage of 11KVA and 66 KVA power line and how it is calculated?

0 Answers   Anglo Platinum, Narnarayan Electrical,

---

In supply RYB are mentioned. But in transformers, why they are mentioning XYZ?

3 Answers  

---

how to select DG set for certain load?

7 Answers   ACC,

---

how is the incoming cable size calculated for a given current rating of a panel??

0 Answers  

---

what is the function of NAT & NAC contacts in breaker control switch (TNC)??

2 Answers  

---

We have three 33kv substations. All of them energised by same source.When i am checking the phase sequence between one substation to other substation (like R Phase to R Phase) by multimeter i am getting some voltage.Near to LT panels UPS panels are there. Can u explain whether any possible to happen like that. In Phase SEquencemeter is showing correctly in both substations. How is it happen. Explain me.Explain me communication signal will produce Phase difference on this case.

3 Answers  

---