HOw can we calculate power factor at HT side.
Answers were Sorted based on User's Feedback
Answer / joseph
Calculating Power Factor at LT or HT side is the same, as
P.F. is simply the ratio between the Active Power and
Apparent Power. Hence, if you have got both these
parameters then just divide Active Power by Apparent Power
(kW/KVA or MW/MVA as the case may be.)
| Is This Answer Correct ? | 26 Yes | 2 No |
Answer / k.shivkumar
Power factor can calculate KWH/KVAH readings
| Is This Answer Correct ? | 22 Yes | 6 No |
Answer / ashokreddyreguri
primary current is the vector sum of no load current and
load component of primary current
phase difference between primary current and primary
voltage gives primary power facter angle
primary power factor = cos (primary power facter angle)
primary power factor is always less than secondary power
factor
| Is This Answer Correct ? | 12 Yes | 5 No |
Answer / channaveer.s
# 2 Calculating Power Factor at LT or HT side is the same,
as
P.F. is simply the ratio between the Active Power and
Apparent Power. Hence, if you have got both these
parameters then just divide Active Power by Apparent Power
(kW/KVA or MW/MVA as the case may be.)
| Is This Answer Correct ? | 9 Yes | 3 No |
Answer / rohtash kathwalia
We can calculate Power factor by KW/ KVA. LT and HT power factor will be same.
| Is This Answer Correct ? | 1 Yes | 0 No |
how to determine kilowatts (real power) is used in energy meter? is it apparent power effect the disk rotation?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
What type of a DC motor would you use for a lift?
Why DC weldings sets preffered over AC considering human safety aspects ?
How to calculate Voltage regulation of 22 KV Over head Line.
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
Is LV shorted in magnettic balance test?If yes why?
define transformer
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
I have suguna 3 hp pump for my agreeculture work.It deliver the water from 45 feet well .I suffered by powercut.During powercut i got 2phase supply only .My question is can i run the pump in 2 phase supply using capacitor?.Can u explain me how to connect the capacitors?
How to Decide(calculate) Bush bar size for copper and aluminiam ?
why wound rotor is star-connected?
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)