Answer Posted / channaveer.s
# 2 Calculating Power Factor at LT or HT side is the same,
as
P.F. is simply the ratio between the Active Power and
Apparent Power. Hence, if you have got both these
parameters then just divide Active Power by Apparent Power
(kW/KVA or MW/MVA as the case may be.)
| Is This Answer Correct ? | 9 Yes | 3 No |
Post New Answer View All Answers
What is the differentional relay...what is the work of this in power Tx. how it is works..
How we calculat the NGR of 3phase Generator, Our generation voltage 11KV
Define conversion efficiency of a power amplifier.
Where can i get practical knowledge of solar system?
how to control dc motor?
what is the need of starter in tube light and what type of starter is used in that?
what is feeder bay?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
What is center gravity load in substation?
Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?
what are the difference between AC lamp and DC lamp
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
why the rotor current becomes in steady state during high slip region? please verify with equations.
pls tell what are doing the three phase motor star and delta connetion with circuit diagram and control wiring .
Testing procedure of DG alternator stability test
