Answer / zahid noor

The question is Power Factor Correction, which means loss
of power on account of Transmission & Distribution at the
end level consumer with respect to Unity Power Factor. ie:
if power factor at consumer level is .95 then consumer has
to install additional capacitors in order to achieve .5
additional pf to reach value to unity.

Answer / gautham

PF correcting the PF to almost unity. The power factor has
to be maintained very near to unity so as to avoid high
currents and minimize losses.
In many industries Static Capacitors and Synchornous
condensors are used for PF correction.

Answer / ibrahim

power factor correction is nothing but the process of
improving power factor

Answer / mani0786

power factor correction means to maintain a leading power factor above .95 it help to reduse
1.panelty by electricity suppliyer
2.voltage regulation at end point
3.cable heating
4 machine work properly

Answer / muhammad abubakar siddiq

Active power is the product of cureent , voltager and power
factor as power factor decrease requireq cureent increse so
losses increses and KVA increases , we have to increase it
close to unity by sereis reactors , parrallel capacitors to
make our system n application run at increased efficiency .

What is meant by full pitched winding?

0 Answers  

---

What is the difference between Earth Fault protection & Neutral Protection

1 Answers  

---

Can CT Secondary left open circuited and why(reason)?

5 Answers  

---

How to calculat the ratio of HT\LT in energy meter

0 Answers  

---

WORKING PRINCIPLE OF VACCUM CKT BREAKER ?

2 Answers  

---

---

why pull the single core cable?

1 Answers  

---

A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram

0 Answers  

---

Why CBCT rating is 50/1A

0 Answers  

---

why do the alternator doesnt have open circuited windings in armature???

1 Answers  

---

What is corkscrew rule?

0 Answers  

---

why we use RYB phase sequence? and somewhere we use UVW ? why?

6 Answers   CSPDCL-Chhattisgarh State Power Distribution Company Limited, MUET, TCS,

---

In all the generators, the excitation supply is DC. What is the significance of DC excitation? What will happen if AC supply is given as excitation supply?

8 Answers  

---