Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mani0786
power factor correction means to maintain a leading power factor above .95 it help to reduse
1.panelty by electricity suppliyer
2.voltage regulation at end point
3.cable heating
4 machine work properly
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the difference between a verilog task and a verilog function?
what is high - pot test. what's its use?????
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
Dear Sir I am living in Jaipur Rajasthan now I did complete my b tech degree in electrical engineering in 2012 Sir how I gate certificate of competency for electrical supervisor
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
What is meant by coupling capacitor?
The ripple frequency in output of fullwave bridge rectifier is a. Half the input b. Twice the input c. Same as input
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
How cmd is calculated in case of energy neters
Safety of on line ups
what are inductive and capacitive voltage transformers.what are their applications
what is PID control in VFD drives?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
