Answer / m nanda kishore

the grid is also referred as infinite bus bar in terms of
synchronisation but it also implies fixed voltage,fixed
frequency,phase seuence,phase voltages

Answer / motilal sahu

INFINITE BUS BAR IS CONDUCTIVE WIRE IN WHICH INFINITE
ALTERNATOR IS CONNECTED TO MAINTAIN fixed voltage,fixed
frequency,phase seuence,phase voltages

Answer / pankaj

infinite bus bars means the whose parameters like voltage,
frquency, phase sequense remains constant even after change
in parameters in the local ckts.

Answer / deepak kumar

An infinite bus bar is a parallely connected network of
ALTERNATORS, whose frequency and voltage remains
constantregardless of power drawn or supplied from it.

Answer / sagar alias jacky

infinite bus bar has constant frequency and voltage......

Answer / pankaj kumar verma

Infinite busbar is a whose parameters like voltage,
frequency and phase sequence remain constanat even change
in the connected load to the infinite busbar.

Answer / satish

INFINITE BUS BAR is a very large conductive circuit in which
infinite Alternators are connected to maintain fixed
voltage,fixed frequency,phase sequence and phase voltages.

Answer / sujan kumar

an improvement to the above answers

an infinite bus bar may be treated like a m/c with large
amount of inertia, so that the frequency will not change.
and the voltage and frequency remains unchanged regardless
of the equipment connected to it.

Answer / swarn

Infinite bus bar is the source where n numbers of
generators are loaded thereby impedance of the system
becomes so high that connecting or disconnecting any load
does not impact on voltage,frequency of the system.
The Voltage , Frequency of Infinite Busbars always remains
constant. This is what is called as Grid also

Answer / anil kumar verma

Infinite bus bar is the node in a power sustem where
many generators can be connected without affecting the
voltage & frequency of the system.

I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?

0 Answers  

why ohms law does not obey semi-conducters?

2 Answers  

Why shunt Generator is not recommended to start at ON LOAD condition???

3 Answers  

how does an encoder work???

0 Answers  

Why inductors are installed in electrical circuits?

0 Answers  

can we use the 110 v primary Tr 240 v secondary step up Transformer as reverse 240 pri 110 sec

3 Answers   Hyundai,

Rotor resistance starter is used to obtain= A increased starting torque B decrease starting current C decrease starting loss D increase efficiency

1 Answers  

In what way does the variable ratio-arm improve the usefulness of the wheatstone bridge?

1 Answers  

I want d.g.set our company

0 Answers  

y we are used signal conditioner in capacitive transducer

1 Answers  

wat s the electronic device used in the fan regulators recently?

2 Answers  

How to check the specific gravity of the two 12 V batteries connected in series to a 24 V UPS and inverter ? will we have to disconnect all the connections and turn off the UPS and inverter or not ? will we have to check specific gravities in each cell of the two batteries ? what is the name of the instrument that is used to check the specific gravity and whats the procedure to check the specific gravity with it ? thanks

2 Answers