if we appling capacitor at above rated what are looses
and what will be happen
Answers were Sorted based on User's Feedback
Answer / sath
capacitor will injuct the reactive power to the line and
inductor will take the reactive power to this line. Because
these to compensate each other. in cause capacitor value
increased the above the rated value consiquently power
factor also increased.Hence the real power loss will
reducted.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / sunil guru
capacitor is an device that has charging plates and stores the charge when energized
if u apply voltage beyond ratings it will get overcharge,iF there is a way or forward connections made to dissipate the charge then every things WILL go right otherwise capacitors will BURST.......(every capacitors have over voltage capacity/for certain time period beyond which if voltage rating is increased cap. will be over-heated first then burst)
Is This Answer Correct ? | 2 Yes | 1 No |
Answer / felixraj
current leads the voltage this reactive(lead) losses is much
sever then lag losses
source acts as load
alternator AVR loss their control and voltage increases
abruptly.
tks
Is This Answer Correct ? | 0 Yes | 0 No |
do we use links in a dc circuit?if so what s its use in it?
why we are used thermistor in motor
what is transformer tap change HT side and LT side
HT motors are generally connected in star, what will be the effect if we connect HT motor in Delta?
6 Answers Equate, Ion Exchange,
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a campus site?
Pls tell me what is the exact current conducting capacity of copper and aluminium cables?how much capacity of cables need to 90kw induction motor&how?
What is an 86-P or an 86-A trip
What voltage is used in Directional earth fault relay? and why?
what is the power factor of an inductive load ? (i) Zero (ii) Lagging (iii) Leading (iv) Unity
I am new guy as an electrical engr. in a 100MW HFO based power project. I am in operations division. I have noticed from last few days, my supervisor sends the last 24 hours energy generation calculation to my plant manager. I have noticed, he calculated last 24 hour's generated energy differences in KWH then he multiplied it with a multiplying factor 960. for example: total difference =2.685 KWH*960= 2577.6 MWH. but he does not not know what is multiplying factor 960?? can anybody explain it??
What is diode fuse ? How it is working?
what is POTT and PUTT explain?