For TV transimission in india we use AM for video and FM for audio. why like t

For TV transimission in india we use AM for video and FM
for audio. why like this? can we use opposite way?

Question Posted / allanki sr

4 Answers
14530 Views
Sony, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

For TV transimission in india we use AM for video and FM for audio. why like this? can we use oppo..

Answer / j.mohamed sadique basha

fm is used for audio and am is used for video we cannot
change that.. reason behind that is for example voice of
human being differ from person to person ...so that we need
tecnology with constant amplitude and variable frequency tha
is principle of fm...
am is used for video because picture size is decided using
frames and number of scannig lines...for example there are
different size of tv like 21 inch,10 inch...in 10 inch tv we
are seeing the same picture but in small size..so that we
need technology with variable amplitude and constant
frequency that is am...
best of luck..

Is This Answer Correct ?

45 Yes

13 No

For TV transimission in india we use AM for video and FM for audio. why like this? can we use oppo..

Answer / abhyarthana

One reason to use am for video and fm for sound is noise. As noise signals are voltages that are added in the information signal, they can change amplitude but cannot change the frequency of the signal. In fm if noise is added, it doesn't change the data since the information is contained in frequency variation. this ensure a good quality of audio signal, when demodulated.

Another important reason is the bandwidth requirement. Video signals have much higher b/w than audio signals. Fm cannot provide this much b/w to signal. Thus AM is suitable for video signal.

Is This Answer Correct ?

9 Yes

0 No

For TV transimission in india we use AM for video and FM for audio. why like this? can we use oppo..

Answer / durgak

AM can also be used for audio but since AM is more noisey
than FM, so FM is generaly used for audio.but in video
transmission, noise doesn't have much impact on video,also
cost implication is justified,since FM transmission is
costlier than AM transmission.

Is This Answer Correct ?

10 Yes

5 No

For TV transimission in india we use AM for video and FM for audio. why like this? can we use oppo..

Answer / balajideee

we can use AM for both video and audio.. But is only for
FM is onlt for audio.....

Is This Answer Correct ?

8 Yes

16 No

Post New Answer

More Electronics Communications Interview Questions

what effect at thersold value on transmission power is increase or decrease in telecommunication

1 Answers Idea,

box1-a box2--a box3-a-1 in 3steps using any operation get a*(a-1)-(a-1)*a in box2

0 Answers Godrej,

no of comparators required for 4 bit parallel A/D comparator

4 Answers

. When a inductive coil connected to a 200 V, 50Hz ac supply with 10A current flowing through it dissipates 1000 watts then which of the following will have least value in ohms a.) Resistance b.) Reactance c.) Impedance d.) None

3 Answers BSNL,

The linearity error for a digital input is indicated by what???

0 Answers

Explain the different modes of flyback converter

0 Answers

where we use zenor diode

3 Answers HCL,

What is meant by inverter?

0 Answers

why we use asynchronous communication in microcontroller.but synchronous is high speed communication than asynchronous.

0 Answers Finolex,

HI IN A MICROWAVE HOP THERE IS A SITE EXAMPLE(A &B).......IN A SIDE I AM GETTING RECEIVING LEVEL 45 AND B SIDE I AM GETTING 55 ...WHAT WIL BE THE PROBLEM..... SUCH QUESTION ASK FROM HUAWEI........THEY TOLD NO RADIO PROBLEM,NO LOS,NO FEEDON PROBLEM.I NEED A EXACT ANSWER......

2 Answers Huawei, Rembam Telecom,

about transmitter

1 Answers BSNL,

Which type of error was eliminated through the use of gray code

1 Answers

For more Electronics Communications Interview Questions Click Here