Answer / sanjeet swarnakar

1. electricity is the flow of electon ,when the potential
difference is created between the two end of the conductor .
2.

On wat basis TSM & PSM are set? Example.TSM=30% n PSM=2.5A....Hw they are set and how we come to know that the particular relay should be set to this value only?

2 Answers  

---

what is difference between differential protection and distance protection and how we calculate the sloop?

5 Answers   OPS, Power Grid,

---

Which pump set is more suitable and economical for liftingwater from 300Mtr borewell? A. Compressor Pump B. Submersible Pump C. Jet Pumps D. 25HP Centrifugal Pump Q. from PSC Test 22-11-2008 Meter reader

8 Answers  

---

electric shock is due to current r voltage.?

12 Answers   National Steel, TCS,

---

We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.

0 Answers  

---

10Hp, 3-phase, 415v, 50Hz induction motor. The above motor is to run on Star-Delta connection, so how do i make following hardware selection 1) MCB, 2) Contactor, 3) Wire Gage (Depending on P-P current or Line Current), 4) OLR, Please tell in detail how to do the above, so as to get the ans. of it even if the Hp rating changes.

1 Answers   Engro,

---

what is relation between HP & BHP

3 Answers   Usha Martin,

---

What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention

0 Answers  

---

0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz

0 Answers   SoftLogic,

---

What are series and parallel isolators?

3 Answers  

---

what will happen when ac is applied resistor,inductor,capcitor?

1 Answers  

---

what are problems caused by the pdu in rack server

0 Answers  

---