Answer / k.prakashchandra

They are also called bypass isolators which are connected
across an equipment especially CB to bypass it for certain
operation.

Answer / er.gurpreet singh

the isolators connected in series for isolating the
particular equipment from the system while the isolators
connected in parallel are used to connect that particular
equipment to earth.they are also called as earth switch.

Answer / k.prakashchandra

Series isolators are in series with the equipment for
isolating it,parallel one is connected across the equipment
to bypass it

what are the differences between MCB and MCCB ?

19 Answers   Bhel, DLF, Omax,

---

Explain what is clipper and clamper circuits?

0 Answers  

---

what voltage generated earth tester meter when we testing the Earth point ?

1 Answers   Cognizant, CTS,

---

7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?

0 Answers  

---

why all selected supply voltages are multiple of 11.i.e440,11 kv,33 kv,66 kv,110 kv etc

6 Answers   Suzlon, TCS,

---

what is the full name of ELCB &MDB <MCB

2 Answers  

---

Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not

0 Answers  

---

is there any chart showing the suitable cable size according to AMP and length ? for three phase motors

0 Answers  

---

what are the problems are there if power factor is leading

3 Answers   NTPC,

---

Why earthing transformer used in Distribution Sub-Station?

3 Answers  

---

why some transmission lines have 7 wires n why some have 3 n 4??

3 Answers  

---

What is the constructional difference between ceiling fan and table fan

2 Answers  

---