Answer / amit khamesra

Guys , i think , it basically depends upon the incoming
source. When u r synchronising grid with a running
generator, u need to synchronise in anti clockwise
direction, Grid being a bigger source shall supply power to
small source initially. If u r synchronising generator with
a already runing system, it shall be done in clockwise
direction as clockwise direction shows higher speed of
incoming generator, which in turn shows the load taking
capability of the incoming source.

Answer / gunasekaran

IF WE do ccw direction it is reverse power condition so
revese power relay is operate and getting trip

how we can calculate earth fault current?

1 Answers   Alchemist,

---

How to reduce current flowing in neutral due to unbalanced load conditions in a three phase system.

1 Answers   IOCL, wbsedcl,

---

Brushless excitation of synchronous generators and motors

2 Answers   AMIE,

---

How Cable Size is determined for a Particular load.

4 Answers  

---

How do you classify the different types of torques?

2 Answers  

---

can we install HT panel & LT panel side by side or how much clearance is required ?

0 Answers  

---

what will happen if frequency is below 50 hz?

0 Answers   Student,

---

Why shunt Generator is not recommended to start at ON LOAD condition???

3 Answers  

---

How can determine cable size with respect to cable length and area in mm2

1 Answers  

---

Hi everyone, I'm Lachuu, recently joined automation company as PLC Engineer. I have certain basic question, I request all big gurus and seniors to answer these question. Because this will be very helpful to me as well starters like me. How to design a control circuit (ex: pick & place - my current project) Yamaha robot PxYx series controller RCX222, using 6 cylinder double acting, plc keyence kv p16r 2 expansion unit for input and output each. How to select panel terminal mcb elcb powersupply. My main concern in some projects how to select dc power supply, mcb rcb(I came across dif bt b c d curves, but stil confusing, pls help me :-(. I would really appreciate all who are going respond to this question.

0 Answers  

---

diff b/w elcb and rccb

0 Answers  

---

what is the method to measure the transformer current carrieng capacity in three phase.

1 Answers  

---